Interchannel delay

[Snamprogetti]

I read here and in other documents that a higher interchannel delay may correct multiplexed measurements for various reasons. Does this apply to a 9205 cRIO module? How can i increase its interchannel delay?

[sisu84]

You can apply the interchannel delay at your 9205 module.

In your Labview project, right click on your 9205 module >> Properties. Increase the value in the Minimum Time Between Conversion box as you like. Remember that the sample rate is linked with the interchannel delay, so if you increase the int. delay, the sample rate decrease.

Ciao!

[Snamprogetti]

Thanks, i'll try when i can. If i change that setting, do i have to recompile the FPGA VI that reads the module?

[sisu84]

---

Snamprogetti wrote:
If i change that setting, do i have to recompile the FPGA VI that reads the module?

---

Yes, you have to recompile the FPGA.

Ciao!