Problem with DAQmx and Real Time PCI-7041/6040E.

[V.GRAF]

Problem with DAQmx and Real Time PCI-7041/6040E.

I have a problem with the Real Time card PCI-7041/6040E, I think it is properly installed because my software run with the traditional NI-DAQ. When I try to use the new DAQmx to acquire one signal, Labview doesn't see any device for de DAQ card 6040E.
Information, I work on Windows XP and LabView v7.0.0 (NIDAQ RT v7.0.0, NI-Serial RT v2.5.2, NI-VISA v3.0.1 and NI-Watchdog v2.0.0).
Could Labview RT run with new DAQmx ?
What can I do to use DAQmx with PCI-7041/6040E?

Thanks for your help !

[peterguy]

Hello V.Graf,

unfortunately DAQmx does not support Real-Time-cards yet. We are working on it but I can not say how long it takes. So,till now, there is no way you can use LabVIEW RT with the new DAQmx.

Sorry...

Regards,

Peter Weber
NI Germany

[dirkounet]

Hello,

I refer to your posts because i am using the PCI 7041/6040E card as well but without any success to make it work. The problem I have already described in the following thread:

http://forums.ni.com/ni/board/message?board.id=170&message.id=120198

Would be nice if you had a look on it, maybe you can help me. BTW, the thread starts with a problem of someone else, the difficulties I encountered are to be found a little bit to the bottom of the thread's page.

Thank you!

Dirk Völlger
Darmstadt

Message Edited by ratschnowski on 07-28-2005 07:14 AM