RT how can i see CPU usage in system mangager...tools>>

[Pratima]

Hi,

         I am also working with RT,I am not able to see CPU usage with my system manager,its showing some VI server error or port error?how should i configure,i gave IP address but use default port address.please solve this problem?

Pratima

[rex1030]

Could you please discribe your problem a little better. Give error codes, discribe what VI you are running, describe the behavior. Use good punctuation and grammar too 🙂


Message Edited by rex1030 on 05-07-2008 04:54 PM

[The Specialist]

Make sure that you have enabled VI Server in the project.  Also a picture of the error would be great.

[Pratima]

hi Specialist,

                  thanks,now i am able to see system manager with start monitoring.my RT vi is using 100% CPU,can u suggest what should i do?

pratima

[rex1030]

You need to put waits in your loops or use timed loops.

[StevenA]

Pratsha

What hardware are you using... Can you tell us a little more about the application?

[The Specialist]

Rex1030 is correct.  Waits inside of loops help with 100% CPU.  Also note that if you are using a cFP, the default action is to run at 100%.  Note this:
http://digital.ni.com/public.nsf/allkb/8CBE08A24018A8F086256F79006CEB12?OpenDocument

Are you using a cFP.

[Pratima]

Hi ,

           I am using cRIO-9004 controller.

Pratima