Hi,
I'm really new to Labview programming, and I'm slowly learning the basics. I'm trying to make a stopwatch that response to an input signal.
The problem is this:
Given a continuous input signal Y (volt). Most of the time, the signal is 0. Sometimes (user input on sensor change the signal), the signal has values from 5-10. When y > 7, the timer start. And then when y becomes < 7 again, the timer stop and output the time the signal stays high than 7. This repeats forever.
Summary: start stopwatch when signal is > 7, stop when signal < 7. Output the measured time.
I can make the stopwatch activate/deactivate with a button, but I don't know how to do it with a signal
I need a block that can be both a control and an indicator (so I can do block = !block to perform boolean switch), but I can't find it and I think it doesn't exist. So I can't do it that way.
How can I solve the problem I described? Thank you.
