Using CLIP - The wizard does not open

[O_Mor]

Hi,

I am trying to use the CLIP for embedding a VHDL code. Unfortunately I cannot configure the IP node nor can I open the wizard from the Component Level IP tab on the FPGA properties. The message says that I don't have the necessary compilation tools, but I do have both XILINX ISE 10.1 and XILINX ISE 14.7 and both work properly. Is there another software I have to install in order to make it?

I use Labview 2016 and PCI-7833R FPGA.

Does anyone have a clue?

Many thanks!

[Terry_ALE]

Two questions:

1. Which version of windows are you using?

2. Did you install the ISE from NI's website? 

[O_Mor]

Hi Terry,

Thank you for your response.

I use windows 10 and I did install ISE from NI's website.

Ori

[Terry_ALE]

That version of ISE is not compatible with Windows 10.

[O_Mor]

Is there another version of ISE that will fit both this model and windows 10 ?