Asking for the Calibration Model for scxi1000

[Jcal]

I m using LabView 7.1 ans national instruments SCXI1000. However, i don't know how to get the calibration on the SCXI1122 and SCXI1102.
For the calibration, do i need to build up the VI program? if yes, can provide some example or further information?

[Jcal]

No on cane sharing out some suggestion?

[George M.]

Hi,

I just sent you an email through NI, but I did not know which modules you were using. Now that I do, I am going to link to the documents that discuss calibrating both of these modules.

For the SCXI-1102, there is an SCXI-1102 Calibration Procedure Manual.

For the SCXI-1122, the calibration procedure is contained in the SCXI-122 User Manual.

In the email, I showed you the VIs to do this in LabVIEW. Have a Great Day!

George

[Jcal]

Hi George
I didn't recieved your email. Can you send it again? thanks in advance. The module that i use "SCXI 1322 and SCXI 1303".

[George M.]

Hi,

Here is the calibration procedure for the SCXI-1322 Terminal Block

Here is the calibration procedure for the SCXI-1303 Terminal Block

As far as calibrating in LabVIEW, I am attaching a screenshot of the VIs you will be using. Please use the context help (Ctrl-H) for a description and information on each VI.

I hope this helps, and have a Great Day!

George

[fsdaq]

Are there any VI's in DAQmx to read/write/transfer the EEPROM calibration constants for modules such as SCXI 1102c and 1520? Right now I am only aware of the Trad DAQ VI's that can do this.

Thanks,

Matt S.

[LYu]

Hi fsdaq,

There is no DAQmx equivalent for this VI. I recommend contacting NI Tech Support via email for any possible alternates:

Contact NI

Thanks,
Lesley Y.