Can I use the SCB-68 together with a NI6703 to attenuate the 16 AO channels

[atoanha]

Is it possible to use a SCB-68 to attenuate the 16 analog output signals

from a NI6703. I am trying to build a multichannel thermocouple simulator.

If it is possible where shall I put the resistors? The SCB-68 manual only

describes the case with the two AO channels that normally exists on a DAQ

card

Software Details: LabVIEW version 7.1

NI Hardware : Multifunction DAQ device PCI-6703

Driver Version : NI-IMAQ

Operating System: Windows XP

[AshwaniS]

Hello atoanha!

It is possible and you should put your resistors on the board.

cheers.