07-26-2006 08:26 PM
07-27-2006 03:19 AM
No, a DAQ card can be configured to acquire from SCXI modules in either parallel or multiplexed mode.
But not both modes at same time
07-28-2006 03:17 AM
07-28-2006 07:18 PM
07-31-2006 05:09 AM
I remember reading that SCXI switch modules are controlled by using DIO lines of your DAQ card in a multiplexed mode
Some DIO lines on DAQ card will be reserved for this purpose
I could not find the relevant documentation
If anybody has any support mateial for this, can you please post it??
07-31-2006
05:31 AM
- last edited on
03-23-2026
10:19 AM
by
Content Cleaner
Is this what you are looking for?
http://digital.ni.com/public.nsf/websearch/86C493E0768EBCFE86256FD4006BCD52?OpenDocument
Cheers
Stuart
07-31-2006
11:30 AM
- last edited on
03-23-2026
10:19 AM
by
Content Cleaner
The PXI-6289 should be able to control both the 1166's in the PXI/SCXI combo chassis and both the 1125's in parallel mode. This KB explains you can control both cards using serial communication through the backplane and a card in parallel. In this case, because the PXI-6289 can control 1125's in parallel mode because it has 16 digital control lines, one through each connector.
I hope that helps!
08-02-2006 02:01 AM
Stuart,
getting an error message, that particuar page is not found
08-03-2006 03:49 AM