SCXI 1140 - Track-and-hold trigger line error.

[cconley]

I am running an SCXI chassis where 1 of the modules is 1140 with a 1301 terminal. I've tried just acquiring a signal, and I receive the following error.
"
Error -10740 occurred at AI Group Config.

Possible reasons:

NI-DAQ LV: A signal has already been assigned to the SCXI track-and-hold trigger line, or a control call was inappropriate because the specified module is not configured for one-channel operation.
"

Any help or insight would be appreciated.

Thanks,
Alex

[e-Cash-Money]

Hello cconley,

I searched our website and was able to find the following KnowledgeBase article in regards to the error you are seeing. Although it specifically references the SCXI 15xx module, I believe that the same information applies to the 1140 module.

http://digital.ni.com/public.nsf/websearch/91C7DE7A2C2C9AC586256A0A001D8B5D?OpenDocument

Take care,
E.Lee