Strain Gauge Amplifier for USB-6009

[DANRFXz]

Hi,

I've built an experiment that uses a single strain gauge on a cantilever beam.  There are three of these beams, each with it's own gauge (350 ohm).  I need a signal amplifier/excitation device to power the strain gauges and give a working input to a USB-6009.  Does anyobdy have any recommendations on what we should be looking to purchase?

Thanks!!

[Bueller]

Hi,

Here's the product page that has all National Instruments devices capable of strain gauge measurements.

However, I would like to point out that the SCXI version of the modules, requires an SCXI chassis , and the SCXI chassis is connected to a 68 pin DAQ device.

At the bottom of the product page, there's a phone number and a " Talk to an expert " links. I recommend using one of those to contact one of National Instruments Technical representatives.

Regards,

Faris A