Analog Output Signal Problem

[PL-ER]

Hello all,

I'm new to LabView, so I hope you can give me a little support.

I created an analog output signal (sine wave) in SignalExpress. I want to run this signal continuously.
I used a sample rate of 1000 S/s, a block size (samples) of 100 and a frequency of 10 Hz.
By looking at my output signal, I can see a a short interrupt after every 100 samples.
Is there any chance to run the signal continuously without an interruption after every iteration?

Thank you for your help

[norloc]

Hello,

I need more information about your project. Is it possible that you give it online?

Maybe you create a signal which has as a acquisition mode finite. Maybe when you made it as continious there will be no interrupt.

Regards