Hi,
This week my team's RoboRIO 2.0 started being completely unresponsive with the Status LED continuously flashing. It does this with and without an SD card inserted.
Things I have tried:
- Reflashing the SD card with the latest image
- Flashing a different card
- Open the RoboRIO case and clean the board with compressed air
No improvements.
I probed 3.3V, 5V and 6V supplies on the different pinouts: all are good.
I followed the steps at https://knowledge.ni.com/KnowledgeArticleDetails?id=kA03q000000kOHkCAM&l=en-CA but I cannot set a team number at step 2. The RoboRio Imaging Tool does not see any device when I plug it in while the Status LED flashes.
Is there anything else I can do?
Thanks,
Simon for team 3360
