Hi there,
I have a roboRIO with Serial #03060F3F that is currently running firmware version 8.8.0f. It hasn't been updated since 2015. The imaging process would fail about 25% of the way through and the roboRIO would boot into safe mode (3 status LED blinks). The NI Max tool would fail to "Erase disk" with "booted into an unknown state". After several attempts with the FRC roboRIO Imaging Tool (version 22.0) and the NI Max utility (Right click roboRIO -> Erase Disk), the roboRIO now no longer boots and the status LED blinks constantly (unrecoverable error according to this page).
I am wondering on if I could get some assistance on a way forward through this problem.
