Re : Mapping (so close ...)

[Nicopsa]

No problem

This is my VI, could you test if you have the same matter ?

Thanks a lot !

[thumble]

Your code works on my side. The only trap is if the nivssdf file is not accessible and you don't look at the error cluster you won't see anything but the led remaining off.

the form of the channel names are i.e.: "Targets/Controller/Hardware/Chassis/DAQ/PXI1Slot3/Analog Output/AO0"

[Nicopsa]

Ok I've finally find the problem. When I add some stuff in my Veristand project, I never completly close it ... To add the map, you must close Veristand. Again a dumb error. Thanks for your giving me the solution !

Now I try to add the map from a txt file. I think I'm not far to get the solution, could you take a lokk on this ?

Many thanks thumble  !

[Nicopsa · Accepted solution]

Problem solve !

See this post for the solution : http://forums.ni.com/t5/NI-VeriStand/Configure-Mapping-with-txt-file-in-LabVIEW/td-p/3292824