Controlling SERVOS Using myDAQ and LabVIEW???

[bbzc]

Hello,

We currently want to use the myDAQ using LabVIEW to control multiple (5) 7.4V servos. However we are not sure where to start. I know this is a bit vague but any help will be appreciated. Many thanks.

-bbzc

[Sam_Sharp]

You will need to provide power to the servos from a power supply, but then you should be able to use a PWM output on the myDAQ to control them.

There's an example here: https://decibel.ni.com/content/docs/DOC-19953

It's also worth Googling 'mydaq servo', as it returns plenty of results.