CPULL DPULL, I need some clarification

[FlorianJ]

Hello community,

I have a question about CPULL and DPULL on my DID 6533 (DIO-32HS) device. I understand, that I can't control those pins via Labview and that the way they are wired (high- or low level- determent the way my open lines behave.

Do I understand this correctly?

Thanks for a short notice whether I'm right or wrong,

Florian

[FlorianJ · Accepted solution]

Problem has been solved. The device used to be controlled via another DIO card, it just happened that some of the channels I wanted to control ended up on CPULL and DPULL. It gave me a headache to figure out that the channels aren't standardized, I just assumed they where. I'll change my card tomorrow and everything should work.

Message Edited by FlorianJ on 04-22-2010 09:20 AM