Home Community Discussion Forums Most Active Hardware Boards Digital I/O Topic

Digital I/O

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

What value(s) (using [putvalue('nidaq',value)]) need to be sent to the ER-8 to open and close individual relays?

What value(s) (using [putvalue('nidaq',value)]) need to be sent to the ER-8 to open and close individual relays?

‎06-29-2001 05:51 PM

I'm attempting to control the ER-8 via a PCI-6052E and SC-2050 adapter board (and associated cables).
0 Kudos
Message 1 of 2
(3,520 Views)
Reply

Re: What value(s) (using [putvalue('nidaq',value)]) need to be sent to the ER-8 to open and close individual relays?

‎07-02-2001 10:36 AM

The best way to control your ER-8 device using an e-series DAQ board is by following the attached flowchart.
Hope this helps.
Filipe Altoe
Application Engineer
National Instruments
0 Kudos
Message 2 of 2
(3,520 Views)
Reply