a program for an oscilloscope GDS-840C

[im25041991]

i need just an example to know how to work with an oscilloscope with labview

[crossrulz]

---

@im25041991 wrote:

i need just an example to know how to work with an oscilloscope with labview

---

So do you know the steps you have to do to manually setup the scope?  If so, dig through the palette and find the functions that will do what you want.  You will need to use the Initialize function (assuming there is one) at the start of your program, before any of the other functions.  And then use the Close functions (again, assuming there is on) when your program is done.

[Dennis_Knutson]

I'm getting an error downloading the driver. Drivers from NI always include at least one example. Have you browsed through the unzipped folder to see if there is any example there? For general examples, you can install a scope driver for tek or agilent scopes. Your manual setup would include setting the horizontal, the vertical, the triggering, etc. The same steps need to be done with the driver. Then you initiate a acquisition and fetch the waveform.

[im25041991]

the driver

[im25041991]

hi

i didn't found the VI to read and write the signal

thanks

[im25041991]

hello

i tried to do the program but i did not know how to to do it

thanks

[im25041991]

hi please some help

[im25041991]

hello,

i did this program, i hope that the program is wright

thanks