[Feature request] Resize terminal behind wire terminals

[Nicola_TUD]

Hi,

I noticed it is sometimes very hard to hit the resize terminal of a node, because disconnected wire terminals appear practically on top.

It is a bit easier, if you select the VI first and then try to resize it. In any case, you might want to consider allowing diagonal resize at the corners.

Nicola

[gregorelectric]

 Hi Nicola,

thank you for your Request. Since your post is a feature request and this is a forum to discuss difficulties and problems, I recommend you to post your request in the Idea Exchange Forum:

LabVIEW Idea Exchange - Discussion Forums
http://forums.ni.com/t5/LabVIEW-Idea-Exchange/idb-p/labviewideas

If your Idea is supported by the community and you get some Kudos, R&D will take a look and consider taking action on changing this.