Blackfin Multiple SPI Devices

[freitas]

Hi guys:

Sorry to post this question, but I really can't make it work!

I can configure each SPI device and they work alone, when I try to config 2 devices, I simply can't get both CS lines to go up!

Note: here is my code, I choose Slave Select 4 so it can be easily accessed via SPI Connector on the board (pin 14).. SS1 is pin 9!

Thanks in advance

edit: oops.. move this topic to embedded please! thanks!

Message Edited by freitas on 09-09-2009 06:47 AM

[Mathan]

---

freitas wrote:

edit: oops.. move this topic to embedded please! thanks!

---

You have to post the same question again in the LabVIEW embedded board. Moving this topic from this board to there is not possible.

Mathan

[freitas]

done!

sorry and thanks