Arduino - Labview Error 5003

[bb1909]

thx its work, wonderful

[islamElkady]

your fix instructions is too easy and it works well,

Thank you so much.

[Sid05]

What is the solution when using Labview LINX though since LIFA is being replaced with LINX?

Error 5003 occurs even when the port is not being occupied in the IDE. One reason I noticed was that aborting the VI vs. stopping causes this error, but there must be other reasons too. Not entirely sure what is the reason. Anybody figure that one out with using LINX firmware? 

[amr_tarek560@yahoo.com]

i am sorry, i did not understood, can you please which value you set with '0' ?

[mmalia]

Thank you very much,
It helped me a lot now, not sure how in 2023, this error still exists

[GianlucaAllegrini]

You are a life saver!

Thank you very much 

[luissanchez1503]

Thank you, this solves it. I had the same issue!

[Devian]

This is perfect!! Thank you very much Thomas Plummer!!

[KAY_SW]

THANK YOU!!!! This checksum error still exists in 2024. And your checksum-fix works perfectly on my Uno. Thank you!!

[Mark-SNC]

The question you all should be asking is why after 6+ years this has not been fixed in the LIFA library!!!  This is inexcusable.

You get what you pay for, and one of the tenets of software is INITIALIZE YOUR VARIABLES!

-mark