Completely messed up Y axis when U32 is formatted in hex

[altenbach]

I run across this in 2020 and was annoyed, so I tested in 2024Q3 and the problem is still there. Just wondering if this is a known bug and where I should report it, if not. Is mentioning it here sufficient?

Basically, I have a graph for an U32 array and want to see all date scaled to the allowable range:

Autoscale off, Ymin=0, Ymax=FFFFFFFF

Bam! If I try to enter FFFFFFFF, It changes to FFFFFFFFFFFFFFFF 😮

... and yes, the same happens if I do that on the X axis!

Note that if I graph U32 data that is all xFFFFFFFF, I cannot see the data at all unless I go back to autoscale. Then it shows as follows:

[Darren]

This issue has been reported to LabVIEW R&D as Bug 2843028.