Can you help me with an electrical diagram?

[Simi19]

Hello,

I`m new into labview and i have to do a electrical diagram...can anyone give me a hint?

[Coq_Rouge]

You do know that Labview is programming tool, not circuit design tool? Do you mean multisim? Multisim is also a NI product. Multisim has it own forum.

[Simi19]

Yes, i know, but what i have to do is - i have a battery connected to a switch that turns on/off a lightbulb. I have to do this. Can you help me?

[F._Schubert]

Connect the - of the battery to the bulb. Connect the + of the battery to the switch. Connect the other side of the switch to the other side of the bulb. Turn the switch on/off. You shouldn't do this on your own when using unhealthy voltages (I assume you use less than 12 V DC). If something burns/explodes, you shouldn't have done this on your own.

Felix

[Simi19]

i`m trying to do this, but i do not know how. Do you have an IM so we can talk ?

[Simi19]

So...if anybody has 10 minutes to help me...as i written above, i have to design a diagram in where i have a battery (here i have to enter the power of the battery) that is connected to a switch, that when is on a lightbulb...turns on. If anybody came help me, pls reply here and i will give you my e-mail address or my IM. 10x

[Coq_Rouge]

You are in the wrong forum. Try this http://forum.allaboutcircuits.com/.

[Simi19]

i wrote here, because i have to do this in labview. i know how to do it in real life, but i do not know in labview...so i wanted someone how knows labview to help me.

[ajimenez]

Here you have a vi, I think is what you are looking for.

[Simi19]

Thank you very much, but i still have a problem...i have LabView 6.1 and that is made in 8.2.1 . Is there any way that i can run it in 6.1?