Hey there, at first: Sorry for my "bad" english...I dont even know how to explain my problem in german, so english will be tough 😉 I made a programm that can read the coordinates of NC Programms (X,Y,Z) and plots it into a 3D Graph (so I am plotting an five achsis milling process). This works fine. But: I have an array full of Data that has been measured while milling (e.g. acoustic emission, cutting forces..etc). I have to color the 3D Plot using this measured data. For Example: While milling the cutting forces raises and the plot should color using the cutting forces from green to red (green: cutting forces below certain limit, red above). So when I read the coordinates/the plot (which describe the contour the tool runs) I can see by its color if everything (the measured process parameter) is fine. I checked the 3D Plot's color vector but I just didnt get how it works. I read that the coloring is mostly affected by the Z- Coordinates (If it would be just affected by the color vector itself!) I hope I could describe my problem properly. Thanks & best regards Bastian

LabVIEW

Coloring a 3D Graph using measured Data

Author

That sounds quite promising. Do you know (maybe just a direction) where I have to look? I am not really fit using the nodes and hopefully it is easier to solve..but thanks again, you are a great help!

Message 11 of 11

(349 Views)

LabVIEW

Coloring a 3D Graph using measured Data

Re: Coloring a 3D Graph using measured Data