Delay recording data using "write to measurement file"

[YKuan]

Hi there,

I am collecting data using DAQ Assistant, and write the data to file using "write to measurement file" functions. I set up an analog trigger signal in the DAQ assistant so that the data will be writen to file after a falling edge signal is triggered.

I would like to delay (about 100 ms) writing the data to file after a trigger signal is being sent. I couldn't figure out how to do so. Hope you can help. Attach is the VI file. Thanks a lot.

Best regards,

YK

[Christian Mergl]

Use the Reference Trigger and read the LabVIEW Help for more Information about it.

Christian