Hello everybody ! I´m new to labVIEW and I want to simulate cRIO on it. I have read all the posts regarding this issue, but none of them really solved the problem. Actually, I read the solution given on ni developer zone titled "How to simulate FPGA targets using the project explorer in labVIEW". However, when I tried to follow the instructions given there, I realised that on opening "Project Untitled" - "New", my system shows only "New" as an option and not "Target Folder" and "Targets and Devices". Why is this so ? I have asked few of my friends, but unfortunately they too are new to labVIEW. I , therefore, request you to help me with this problem. Please reply in simple language, that I (a beginner with labVIEW) can understand ! Many thanks for your help ! Herschelle

Hi Herschelle, LabVIEW FPGA for LabVIEW 2011 SP1. LabVIEW Real Time for LabVIEW 2011 SP1. These downloads will give you the evaluation mode of both of the modules for 30 days free of charge. Alternatively, you can also buy the software online via the software product pages. FPGA Module Product Page. Real Time Module Product Page. I hope that this helps!

LabVIEW

How to simulate cRIO in labVIEW ?

Solved!

Author

Hello everyone !

Finally after lots of trials and errors, I succeeded in simulating the cRIO. Many thanks to dkfire and especially Alex. T for their help and guidance.

Thanks again,

Herschelle

Message 11 of 11

(651 Views)

LabVIEW

How to simulate cRIO in labVIEW ?

Re: How to simulate cRIO in labVIEW ?