LabVIEW FPGA and Xilinx boards & kits

[Vincent_Claes]

Hi Graziano,

I am having the same ideas as you... I put my 2 cents on that LabVIEW will release such a tool soon and at the moment they are testing in it the academic field.

Kind regards

[Graziano]

Hi fpga.be,
   maybe it's just interesting to know if they planned to release commercial products... that'll be a good question I keep for NI week

   Have a nice day!

graziano

[parmenides]

Hi !

I just got this new board and tried to get the samples get running.

But after compilation I get an error 1063

with the hint (I have only the German version so this is a try of a translation from German) like " possible connection not found"

Board is in JTAG Boot mode

Since I am new to Labview it would be great id someone could provide me with some hints

[CarlaU]

Hi parmenides,

Did you install LabVIEW DSP 2.5 after installing LabVIEW FPGA 8.5?  And does error "1063 unidentified error" occur when trying to compile an FPGA VI with elemental I/O? If so, the first suggestion that I have is to try and run a repair on LabVIEW FPGA. If this does not work, then I would suggest contacting NI Support via email or phone in order to troubleshoot this issue a bit further. I hope this helps!

Carla

[parmenides]

Many Thanks!


I reinstalled and everything works fine now.

[toshas]

hi!

can anybody explain to me, how i can get access to ethernet interface on my spartan3e starter kit board.
avaible only switches, buttons, leds, lcd, vga, rs232, ps2, dac, adс, strataflash , spi, 1-wire, exp slot.

what's about ddr memory ?

thx!

sorry, my eng so bad (

Message Edited by dsff on 03-30-2008 03:35 PM

[gregc]

---

@kesakul wrote:
Hello, I need to find out what Xilinx Boards & Kits are directly programmable from LabVIEW FPGA software. I didn't find any consistent information on this topic

---

We did not add these lines to the IO because of the stack driver needs. This summer we are updating the driver and could add the line. greg crouch at NI

[toshas]

ok, thanks, i will have been waiting.

[toshas]

i hope you can add ddr-memory and all fx2 pins too...