AT-MIO-16X using NI-DAQ5.1 on Win98 (cross posted from the multifunction daq forum)
I am
setting up a spare board after one failed in system - the first board
reported failed when the Test Resources button was pressed.
A second board was tried in this system, with no success.
When
setting a second (similar PC specs) system up (it had been shelved),
the referenced directories are not being created during
the
installation of NI-DAQ and board. If I install and set the board up as
previously configured, matching the address/irq/dma channels,
the resource test reports "Not responding to the first IRQ". (No conflicts with resources reported.)
After
reading other postings (searched forums/knowledgebase, etc.), I tried
setting only the base address, and the resource test passes.
Unfortunately,
when set up in this manner, the AIO and DIO seem to work but the
sinewave generator (test resources again) does not -
nor does waveform generation in our application.
