Relay Martix

[pratheek]

Hello Everyone

I am completely new to Labview. My problem is I am trying to run a project designed on Relay Matrix. When I am trying to run it I am getting a lot of errors even after uploading all the files required. It is asking for the files as shown in 1st pic. but even after uploading them I am getting errors and warnings as in 3rd pic. I tried to upload the whole project, but I am unable to do so. I dont know where I am doing the mistake. Could some one help me with this issue please. Thanking you in advance 

[altenbach]

Can you explain what you mean by "uploading"?

[pratheek]

Sorry... Uploading might not be the correct word. I mean adding all the required sub vi's it is requesting for..... 

[HeinzG. · Accepted solution]

Hi pratheek,

the project explorer sotres the paths of the VIs and other files (e.g. DLLs) you use in the project. removing or renaming the files on disk causes the issues you are confronted with. See this link:

https://www.ni.com/docs/en-US/bundle/labview/page/resolving-project-conflicts.html

Kind regards 

Heinz