Re : Re: Re : STANDA MOTOR AND BUILDING AN EXECUTABLE APPLICATION

[FEUERSTEIN]

But it should be a *.usm format
Julien

[FEUERSTEIN]

I am using Labview 8.2

[jjcimon]

sorry, I am not at my office today , i can't open 8.0.2 could you send in  7.1?  or just give me an image of the block diagram?

[FEUERSTEIN]

I am using the motor 8MR191-28
the controller 8SMC1-USBh-B1-1
no dll files
Julien

[jjcimon]

then development kit for labview from standa.it   for   8SMC1-USBh - Microstep Driver (USB Interface)  ?

[FEUERSTEIN]

Do you wanty a picture of the block diagram?
Could you tell me how to create a 7.1 version?
Julien

[jjcimon]

instead I downloded the development library for labview    from standa  

 I ll try to compile, but I want to make sure I understand , is the directory you have to specify  contain vi like this?    Get State (uSMC)

[FEUERSTEIN]

Hello,
I don't think so since I never got a message of error about a missing vi, those vi in uSMC are use correctly i guess?
What i observed is if i remove this config file or the link to the config file the prog doesn't work in both case (full program or executable version one)
So I suspect that something is going wrong with this file, I am not sure of course but i guess.
Regards
Julien

[jjcimon]

please try this

[jjcimon]

did yu try exemple.vi?

a config file should be specified directly in the application(vi), since I have no acces to the usb I am suggesting to verify with Standa.it  They would know for sure.