Strain Gauge Signal

[yjr]

I have two strain gauges, and I want to get both signals. How to connect so that I can get them. For now, the two wave charts have the same output, even the strain is different.

[RavensFan]

What is that express VI you are using to get the signal?  I have never seen that one before.

It looks like it is set up to only output a single value considering the output terminal says "C/AI0 (AI0)"  How do configure that express VI for multiple channels?

There is no way to get a 2nd value out of it right now since it is only outputting a scalar value.

If you attached your actual VI, then we can poke around in it, figure out what that express VI actually is, and open up its configuration panel!

[yjr]

I use the MyRIO, and I am not sure how to use it to get two signals