Re : Wireless Syystem (WLS 9163)

[luis_ferreira]

Hello Forum.

I am using the following equipment from National Instruments:
NI WLS 9163
NI 9219

I set 9163 as the NI WLS wireless system through an ad hoc network.
I and acquiring the values ​​of resistance (voltage with custom Excitation) of load cells wired in full bridge.
Everything works!

However, the acquisition rates are very low!
I can not get acquisitions with more than 2 Hz (high resolution)!

Will can help me on the following issues:
This is because the equipment I am using?
How can I change that with this equipment?
There is another wireless system from NI, with better results for this application?

I appreciate the help!

(Not sure if this is the most suitable place, also posted in Wireless Sensor Networks)

[JérémyC]

Hello,

What kind of problem do you have if you choose to get data at a higher rate than 2Hz ?

Which version of DAQmx do you use?

Could you post a screenshot of your configuration in MAX and tell us which IDE do you use? Is it LabVIEW?

Do you have a VI to post?

Regards,

[luis_ferreira]

Dear Jeremy C.,

Thank you for your answer. I saw that this was not the right place for this message. You can visit:
http://forums.ni.com/t5/Multifunction-DAQ/Wireless-System-WLS-9163/mp/2101306 # M72264

Have added some prints.

Thank you!

[JérémyC]

Hello again,

Allow me to correct your link : Wireless System (WLS 9163)

Regards,