keeping the correct power after saving the data

[Naturalarch]

I got a question about the data saved with the scope 5124 in I16 format

the data is downcoverted with the 5600, and than saved with the scope...but how can i transfer the correct levels, or recalculate the correct power levels..?

thanks

Joost van Heijenoort

[Naturalarch]

I allready found out how to do this...

a now save with the data the Gain and offset from the scope, if you than later do the following

Y=data*gain + offset

the data is to the correct power level restored..

regards

Joost