msb & lsb

[aznw82]

i'm new to labivew application, and i was trying to create a this program that will allow me to send messages to another system through RS485.
i got this document, it said that i have to put "msb & lsb" how do i do that in labview? so, i'm not sure if i should it send in acsii or binary or hex.

[andre.buurman@carya]

Duplicate message. http://forums.ni.com/ni/board/message?board.id=170&message.id=288208

Don't post a questions twice, it may take some time, but eventually you will get a respons if you've provide enough information.


Message Edited by andre.buurman@carya on 12-04-2007 02:54 PM

[K_Bull]

Duplicate: