I currently have a cFP-RTD-122 ( three of them) on and cFP 1800 Module.
I have been able to make good measurements with platinum 100 Ohm, .00385 coefficient sensors. Measuring in the Celsius scale.
I
also have been able to use my 120 Ohm, Nickel, .00672 coefficient
sensors using a sophisticated vi that one of my co-workers developed.
It uses the actual impedence, and converts it into degrees C.
WHat
I need to be able to do, is write to the FieldPoint session and
programaitically switch between ohms (0-400) and Degrees C in the range
category. I founf that one of them is "adressed with a 1B hex, and the
other with a 1E hex. I cannot figure out however figure out how to
change that configuration via LabVIEW. Please Help.
Chris
One should welcome adversity as an opportunity to excel.
