I am running two devices, a Bertan high voltage source and a Hewlett Packard multimeter, with an GPIB-ENET/100 setup, and the Hewlett is giving an error when I address a command to the Bertan. What can I do to determine the problem?

Sven · ‎04-18-2002

Hewlett Packard 34870A multimeter
Bertan 225 20kV high voltage source
NI GPIB-ENET/100 ethernet to gpib connector
last gpib command was:

ibwrt (UD1,"T1",2 (0x2))

where UD1 is addressing the Bertan (UD0 addresses the HP)

pavanb · ‎04-19-2002

If it's an instrument error the manual will be helpful. For GPIB communication refer, GPIB Error Codes and Common Solutions . I hope you have the latest GPIB driver available from http://www.ni.com/support/gpib/versions.htm. If you don't, follow the steps from www.ni.com/support/install

LabWindows/CVI

I am running two devices, a Bertan high voltage source and a Hewlett Packard multimeter, with an GPIB-ENET/100 setup, and the Hewlett is giving an error when I address a command to the Bertan. What can I do to determine the problem?

I am running two devices, a Bertan high voltage source and a Hewlett Packard multimeter, with an GPIB-ENET/100 setup, and the Hewlett is giving an error when I address a command to the Bertan. What can I do to determine the problem?

Re: I am running two devices, a Bertan high voltage source and a Hewlett Packard multimeter, with an GPIB-ENET/100 setup, and the Hewlett is giving an error when I address a command to the Bertan. What can I do to determine the problem?