Connection to the RT target has been lost

[SC1]

All,

  I need somone help to resolve the following error message:

  "Waiting Connection to the RT target(CVS1450) has been lost"

This error message display when I ran the attached program. I'd put in a break-point and walk through the code but it's not obvious when the error message pop up.

I have CVS-1456 and Prosilica camera connected to the USB port-A. Then intend of the attached program is to acquire an image from the attached camera, share the image acroos the network and locate a light pattern.

Thanks,

[SC1]

I'd like to add more inforamtion to my previous posting as follows:

Some how I can't re-deploy the code to the CVS-1456 after the system crash. I can ping the CVS with good respond, ftp to the CVS without any issues and IMAX still see the CVS. I tried to re-boot the CVS-1456 may times without any success to re-deploy the code from the project explore. 

SC1 

[SC1]

Please ignor this posting because Vivek from NI is helping me over the phone.

[SC1]

Now I can re-deploy any code to the CSV-1456, thanks to Vivek from NI support. Just wants to put a note in here just in case some else has the same issue. To work around this issue, Vivek recommended me to reformat the CVS-1456 and re-install all necessary software and drivers to the CVS. This also fixed flashing LED status(flashing 4 times). Make sure you make a backup of you CSV-1456 setup after every is working again, I've learned my lesson the hard way. But I still don't why my code crashing the CSV-1456 from the beginning

Thanks a million to Vivek for walking me through the CVS-1456 setup.

SC1