Vision Assistant fails to generate LabVIEW code

[RichardM]

Hi,
Apologies for the very long delay in responding. . .
If I recall correctly (it has been a while!), a new release of the vision software came about shortly after I had this problem, and I installed that which resolved the issue.
If I remember differently, I will post an update.
Richard

[JSch]

Hello all,

I'm running into the same issue. It was working just fine and than it failed to create a Labview VI. It directs me to the MyOutput file.

I'm using Vision Assistant 7.1.1 and Labview 8.0

Please advice if you can.

Thanks

Juergen

[Jaidev]

 Hi,

If you are using LabVIEW 8.0, you need to use Vision Assistant 8.0 or up. Anything below 8.0 will not give you the desired result.

Jaidev