full programmable control system

[granada]

hiii

i want a full programmable controlling system of NI to control operation of testing some materials in three dimensions X,Y and Z from a personal computer ...

so i think that what i need is programmable controlling board and three stepper motors for each direction  and i dont know if its necessary anything else ...

so what can u suggest to me a system to buy and do i need anything else ?? 

thanx ...

Ahmed

Granada University

Spain

[Jochen]

Ahmed,

with the information that you have provided, I suggest the following components:

• 1  PCI-7334 (motion control device)
• A stepper drive (either a single four-axis stepper drive or 3 one-axis stepper drives)
• 3 stepper motors (you will have to select the type that fits best to your application requirements).

This is one possible option, but depending on your needs there are also completely different potential solutions (e. g. a real-time controller or an FPGA based system with the NI SoftMotion development module).

If you provide more information about your requirements, I can help you more specifically, but an even better option would be to talk to an NI sales representative in Spain.

Kind regards,

Jochen Klier
National Instruments