Re : is anybody here has used IBL2403-CAN module from technosoft before?

[echomice]

Hey, is anybody here has used IBL2403-CAN module from technosoft before?I want to have three step motors and one DC motor in control . this is supposed to be achieved by using four motor drivers in a CAN bus. The driver module is IBL2403-CAN and I have no other choices.I have no idea about how it is and what to do. Do i have to buy the interface card?in another way, the motor driver can be executed via the TML commands. may I import these inside labview as using other languages(c/c++)?

hope to hear from ppl have experiences

Cheers!

[JB]

We have just started a new project with an IDM640 from Technosoft. Unfortunately it is a little bit to early to share a big experience. However, some ideas :

• What do you mean by  "Do i have to buy the interface card?" ? Wich interface do you mean ? On the PC side you will need a CAN interface from NI to communicate with the drivers.
• Technosoft sells a TML library for LabVIEW. Even though it is not the cleanest code I have ever seen, it should at least work and will be the easiest and fastest way to communicate with the drivers by LabVIEW.

[echomice]

Glad to hear ur reply. the Interface card I said is the one u shown, either from NI or from other manufactories.But I don't have it,neither our project. However, I think it should be possible to use TML and command on the drivers which connected as Canbus. I agree with u that import TML in Labview seems the easiest way, but Im not clear with it.

waiting for more messages

cheers