Hello, I just started in a lab using a PCI-6703. I have been assured that it was working before I arrived. However, it was installed on a computer running windows xp. We have installed it on an upgraded computer running windows 7 (no sp1). Device manager and NI-MAX can both see the board and it responds to being disabled and enabled through device manager. However whenever I attempt to run any test through NI-MAX I encounter error 50152. I have disconnected the cable leading into the board from outside the computer, so at this point there is only the board sitting in a pci slot. If I could get some advice on how to proceed that would be awesome.
