NI 9862 CAN configuration in matlab/simulink

[Michael1909]

Hi,

I have a problem with the NI 9862 CAN module. I want to use matlab to comunicate with the CAN port, however when I try to configurate the CAN device, MATLAB crashed.

I use the Module with the NI cDAQ 9178. I installed the Vehicle Network Toolbox Support Package for National Instruments NI-XNET CAN Devices.

[ZYOng]

I would recommend you try the NI-XNET Bus Monitor first. If the Bus Monitor works, the NI-XNET driver is working properly. You will have to reach out to Mathworks technical support for the assistance on the Vehicle Network Toolbox Support Package.

[Michael1909]

I don't have problems with LabView and it also works with the Bus Monitor.

But thanks for the answer, I try to reach the technical support.