Open Traditional NI VI file using Labview 8.5

[yusof]

Hi,

I want to open this VI that I attached below using labview version 8.5

But when run this VI, the error message pop out like below:

I suspect this VI using traditional NI component.

How can I run this VI using my current version of Labview?

Thanks in advance

[JB · Accepted solution]

Yes, you're right. These are Traditional DAQ VI's.

Install Traditional DAQ 7.4.4 (WXP or W2000) and ensure to enable the LabVIEW support while configuring the installer.

PS : LabVIEW 8.5 and Traditional DAQ are not supported by W7. See here (OS<-->LV) and here (DAQ<-->LV).