To what limits (lower and upper) are the PXI-6052E boards calibrated for their various gain settings?

[Stephen_@_HII-Ingalls]

I am trying to get some boards calibrated by our metrology lab, but I can't find the relevant information.

[Sarah Thompson]

All of our current calibration information and procedures can be found at http://www.ni.com/support/calibrat/. Post again if you were unable to find the information you need.

[Stephen_@_HII-Ingalls]

I've viewed all, and downloaded most, info at the link that you've mentioned. Unfortunately, the data I'm looking for isn't there. In the E Series Calibration Procedure document, there is an extensive listing of tables that contain calibration data points for a variety of E series boards. However, the 6052E board isn't listed. Elsewhere on the ni website, there is a note to use the 6034E/6035E tables for the 6052E boards. These tables do not contain all the gain settings for the 6052E. I would assume that the 6052E boards were factory calibrated at all possible gain combinations.