Home Community Discussion Forums Most Active Hardware Boards Multifunction DAQ Topic

Multifunction DAQ

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

USB-6000 shows up in NI MAX, but not in NI Device Monitor, and unable to perform Self-Test

Solved!
Go to solution

USB-6000 shows up in NI MAX, but not in NI Device Monitor, and unable to perform Self-Test

‎12-21-2017 01:43 PM

I'm having trouble setting up an NI USB-6000. I'm able to see the device in MAX, but I'm not able to right-click on it to perform a Self-Test. In addition, the device does not show up in NI Device Monitor. I'm running LabVIEW 2017 (32-bit) [f1] and DAQmx 17.1.1, but I've yet to begin trying to use LabVIEW with the device. So far, I've only tried repairing DAQmx and reinstalling it from scratch, both to no avail. Any help would be very appreciated!

0 Kudos
Message 1 of 2
(2,358 Views)
Reply
Solution
Accepted by topic author carter252

Re: USB-6000 shows up in NI MAX, but not in NI Device Monitor, and unable to perform Self-Test

‎12-22-2017 04:20 PM

Have you looked at our article about that behavior?

 

This article talks about the behavior you are describing so follow those steps and see if it solves your issue.

Casey G.
Message 2 of 2
(2,321 Views)
Reply