INestor,I thought I would bring this to your attention. I do not know if this issue has previously been discussed or not. If it has and your already aware of it then accept my apology.
It seems like the DSWPK_5 Dipswitch is malfuntioning and returning errors. Below I have posted my simple test circut you take a look at. I tested the rest of them and they are O.K.. Just this is is causing problems.
Here's the files and Error Log:
Too few parameters for subcircuit type dpswpck5j1 (instance: xxj1)
Error: unknown subckt: on line 198:xmm1 1 0 xxmm1_368330984
Error on line 198 in C:\DOCUME~1\OWNER\LOCALS~1\TEMP\02.CIR.cir: xmm1 1 0 xxmm1_368330984
unknown device type - error
Instrument operation performed (2007, August 07, Tuesday, 22:15:14)
| Instrument Analysis:Transient Analysis
| | Plot title:
| | Analysis settings
| | | Initial Conditions:Automatically generate initial conditions
| | | Starting time (TSTART):0
| | | Stop time (TSTOP):1e+030
| | | Plotting increment (TSTEP):automatically calculated (less than:1e+030)
| | | Maximum time step (TMAX):automatically calculated (less than:1e+030)
| | Perform consistency check
| | Variables from analysis
| | | Show device values at the end of the simulation
| | Representation as SPICE commands
| | | begin-scope page
| | | checknodes 3
| | | save all
| | | iplot all
| | | set trtol = 7
| | | set itl4 = 100
| | | set convlimit
| | | set rshunt = 1e+012
| | | -param hrange 0 1e+030
| | | save
| | | tran -env-options 1e-005 1e+030 0 1e-005 auto_ic auto_tstep auto_tmax
| | | if-error end-scope audit-log-show
| | | show all
| | | showmod all
| | | end-scope
| | Multisim Default Analysis Options
| | | Truncation error overestimation factor: 7
| | | Upper transient iteration limit: 100
| | | Enable convergence assistance for code models
| | | Shunt resistance from analog nodes to ground: 1e+012
| Output from instrument analysis
Message Edited by lacy on 08-07-2007 09:38 PM
