Object Change

[markoma]

Hi Folks

I  am new to Ultiboard, and one of my friend made some Pcb for me and now i have to change them a bit but i am lost,

In the Ultiboard file on my PCB i have a connecotr that have 80pin with a special design, now the manufacturer chage that connecotr to a 120pin version and i have to change some holes on the cb and havt to rebuild the connector object!

How can i do that?

is there any step by step?

i am cnc person and not electronic guy so sorry if my qestion is to dumb for some experts here.

thx,

marko

[GeorgJ]

Hello Marko!

As far as I understand you want to change an existing Ultiboard layout without having the Multisim Schematic.

Multisim and Ultiboard are tied together very tightly, which means that you select components

and create nets in Multisim. Then you transfer the nets and components to Ultiboard where you create the layout.

However, it is also possible to create/change a layout in Ultiboard without the help of Multisim. However, a few extra steps

are needed. I found this Knowledgebase that might help you:

How Do I Create a PCB Layout Without A Netlist in Ultiboard?

http://digital.ni.com/public.nsf/allkb/4F57C266E94EA734862571CB0048BFA5?OpenDocument

I hope that helps,

  Georg