I have four 22 section symbols in four subcircuits. Whenever I update a symbol it changes each section to a difference refdes. That's 88 subsections all that get named with different refdes. It takes 3-4 minutes to manully rename each subsection back to what it should be and grouped in one part. It takes many hours to complete the job.
This is because theis design is very large (44 pages). I'm nearing the addressing limit of a 32 bit app, which will be another serious problem.
I can select all the subsections in the table view, but when I try to renumber them it only allows one to be renumbered at a time.
Is there some way I can change the refdes on all these subsections to match again all at once rather than one subsection at a time?
Thanks.
