回复： Re: 回复： Re: 回复： Re: 在MAX的设备与接口下没能发现我的硬件设备

[fa0211]

我想用LabVIEW来控制Agilent的仪器，在安装了NI VISA4.0和Agilent IO Control后在MAX的设备和接口下有No VISA resources found 警告，也不能找到已连接的仪器，但在LabVIEW环境的“已连接的仪器”下却能找到。 

[ian_fung]

It is also depending on whether you are using the NI or Agilent GPIB controller. Read following literature for more information... 

Tips on using Agilent GPIB Solutions in National Instrument’s LabVIEW Environment 

[fa0211]

如左图，在Agilent Connection Expert（14.0）的tools 选项下没能找到Enable Agilent GPIB cards for 488 programs.而ＭＡＸ设备和接口如下图：

[fa0211]

不好意思，图太小了,再发一次。我用的各软件及版本如下：

NI-VISA 4.0

MAX   4.6

Agilent IO Libraries Suite   14.0

NI 488.2   2.7.1

[ian_fung]

This is the version Agilent Connection Expert that I used...

 

[fa0211]

我的Agilent Connection Expert如下，但在MAX和LabVIEW“已连接的仪器”下还是不能发现设备……

[fa0211]

以上都是在我配置了Agilent Connection Expert的情况下观察到的

[ian_fung]

Have you tried enable the NI VISA Passport for Tulip?

See Page 5 Step 6 in this document... 

Tips on using Agilent GPIB Solutions in National Instrument’s LabVIEW Environment 

[fa0211]

我也是这样使能 NI VISA Passport for Tulip的，但怎么会出现我说的情况呢？

[ian_fung]

Let go back... are you using the GPIB controller from NI or Agilent?

If you are using Agilent GPIB controller, may I suggest that you re-install all necessary drivers following that document? 

Message Edited by ian fung on 04-12-2010 08:35 PM