Hello, I'm using LabVIEW 2010 and the cRIO 9073. I initialize most of the memory at the beginning of the application and then some measeurement loops run in parallel. When I start the application from LabVIEW over the run button, the application starts quickly and works fine. The same application compiled to a real-time exe starts very slowly. I takes about 2 Minutes till the measurement loops will be reached. The application is too complex to attach it. What could be the reasons for this behavior? I expected, that both versions run similar. Regards

Real-Time Measurement and Control

Hmmm 2 minutes seems like a long time, but with a full up scan engine then it maybe so.

Message 11 of 11

(766 Views)